Adjusting the Alignment with DNP DS40, RX-1, and DS620
Darkroom Booth 2.5 or Higher | Documentation
The strip alignment comes preset and should be close but printers vary and with paper changes may need slight adjustments. With the DNP DS40, DS620A and the RX-1 there is a centering adjustment that allows you to fine tune the centering on the cut line. The photo below shows a 2x6 print oriented how it comes out of the printer. In the printer properties dialog window there is a Fine Adjust section. you can enter negative or positive numbers to move the 4x6 image up and down or side to side.
The bleed may also be helpful this will give you the option to zoom in or out.
Related Articles
My photo strips are off center? (Understanding Bleed)
Darkroom Booth | Documentation First, an explanation about Bleed. Note: The bleed adjustment is not for ...I am only getting a single 2x6 and it is cut in half
Darkroom Booth | Documentation Most dye sub printers like ...How do I set the 2x6 vs 4x6 cut on my printer?
Darkroom Booth | Video instructions Darkroom Booth can automatically set ...How do I adjust green screen drop out?
If you are having trouble and your green screen is not all dropping out properly, the auto feature may not be "seeing" enough of the background to accurately analyze what to drop out. You can turn off the auto and lock it to green or blue to improve ...How do I Add My Printer?
Darkroom Booth 2.5 or higher | Documentation Adding a ...