Darkroom Booth | Printer And Printing | Knowledge Base
Printer and Printing
FujiFilm ASK-300 Printer Setup and Configuation
Adding a print preview with a cancel option in Darkroom Booth
Darkroom Booth 3.0.840 or higher | Documentation You can add a preview/review at the end of the session ...
Limiting the number of copies in Darkroom Booth.
Darkroom Booth | Documentation You can limit the number of copies using a ...
Printers in Darkroom Booth 3.0 - Webinar
Darkroom Booth 3.0 | Webinar
How do I add a copies prompt?
Darkroom Booth | Documentation You can add a prompt for copies before or after a ...
How do I know how many prints I have remaining in my printer
Darkroom Booth 2.5 or Higher | Documentation If you have a directly ...
My strips are not saving in the Prints tab
Darkroom Booth | Troubleshooting Guide First, make sure that Print ...
I am only getting a single 2x6 and it is cut in half
Darkroom Booth | Documentation Most dye sub printers like ...
Troubleshooting white lines on the edge of prints
Darkroom Booth | Troubleshooting Guide In the Global Settings section under Printers ...
Adjusting the Alightment with DNP DS40, RX-1, and DS620
Darkroom Booth 2.5 or Higher | Documentation The strip alignment comes ...
My photo strips are off center? (Understanding Bleed)
Darkroom Booth | Documentation First, an explanation about Bleed. Note: The bleed adjustment is not for ...
How do I set the 2x6 vs 4x6 cut on my printer?
Darkroom Booth | Video instructions Darkroom Booth can automatically set ...
How do I print to a card printer?
Darkroom Booth | Documentation Most ID card printers print on 2x3.25 ...
How do I do a single 2x6 Print?
Darkroom Booth | Documentation You can choose the size and quantity of prints in the main ...
How do I Add My Printer?
Darkroom Booth 2.5 or higher | Documentation Adding a ...
Windows printer not printing from Darkroom.
Darkroom Booth | Troubleshooting Guide Step 1 I added my printer to Booth but nothing is ...